Basement siding Riga Brick | alta-profil.ua
The new geometry of Riga Brick collection facade panels simplifies the technical part of facade mounting. The increased strength and richer colors have made the new collection more durable and resistant to external factors. The non-standard decor and contrast will ideally blend in the most daring design solutions when you decorate your home. The compactness and ease of mounting the panels in this collection are intended to save your time when you cover the facade. The height of the corner element is 0.47 m.
Length: 2000 mm
Width: 45 mm
Length: 3000 mm
Available in 5 colours
Stone, Brick, Kansas, Balkan Granite, Tibet, Rome, Granite, Alpine
Nevada, Granite Carpathian, Pamir
Arizona, Altai, Dolomite, Granite Sayan
Montana, Caucasus, Zlatolit, Travertine, Cairo, Carthage, Ural Granite, Crimean Granite, Colorado, Alps, Onyx, Athens
Alexandria, Basalt, Topaz, Stone gray
Used for mounting of siding panels: Alta-Siding, FLEX, Kanada +.
1170х50х42 mm (LxWxH)
Used for mounting of finishing siding plates (example of door and window openings)
1170х50х30 mm (LxWxH)
Used for installation of siding one-fractor BlockHouse.
1230х50х68 mm (LxWxH)
Used for installation of siding collection two-factor BlockHouse.
1330х50х61 mm (LxWxH)
Used for mounting facade panels Atik, Fagot, Rocky stone
1305х73х30 mm (LxWxH)
Used for mounting facade panels Brick, Stone, Granite.
1380х73х30 mm (LxWxH)
Used for mounting external corners or near-window slopes
Used for mounting with metal suspensions.
Mounting is possible by moving from left to right, completing mounting on one wall before moving on to another one. The panels are designed for mounting only on a vertical surface.
The front panels and all components must be attached to the crate only through the specially designed holes.
Nails or screws must enter the fastening frame in the strictly perpendicular way and strictly in the center of the holes in the planks and panels.
Leave a small distance between the top edge of the screw cap and the panel.
The panels are fastened with nails or screws after every 30 cm.
If you want to highlight the front panels, you can use the J-trim plank as the initial one
The outer corner is installed on the joint of two walls in place.
Variants sheathing fastening and facade panel:
2. Facade panel
3. Ventilated facade
4. Rail 50x50 mm
5. Rail 25x25 mm
8. Waterproofing film
ORDER FRONT PANELS