Clinker brick

Mounting is possible by moving from left to right, completing mounting on one wall before moving on to another one. The panels are designed for mounting only on a vertical surface.

The front panels and all components must be attached to the crate only through the specially designed holes.

Nails or screws must enter the fastening frame in the strictly perpendicular way and strictly in the center of the holes in the planks and panels.

Leave a small distance between the top edge of the screw cap and the panel.

The panels are fastened with nails or screws after every 30 cm.

If you want to highlight the front panels, you can use the J-trim plank as the initial one

The outer corner is installed on the joint of two walls in place.